Linear Security Camera RE BWC1 User Manual

PRODUCT DESCRIPTION  
1. REMOVE CIRCUIT BOARD  
Linear’s Model RE-BWC1 (P/N ACP00886A) CCTV camera can be installed inside  
the RE-1 Entry System. The camera provides a video signal for viewing the area in  
front of the entry system  
RE-BWC1  
DISCONNECT THESE  
TWO CONNECTORS  
The camera is continuously powered by the RE-1.The camera’s infrared light emitters  
illuminate the area directly on front of the entry system for nighttime or low light  
operation.  
REMOVE  
CIRCUIT  
BOARD  
Black & White  
CCTV Camera  
The camera focus has been factory adjusted to a range of three to four feet.  
The RE -1 CAMERA jack is used to connect the camera to the main circuit board with  
the single-ended modular cable supplied with the camera.This cable routes power to,  
and video from the camera.  
The RE-1 VIDEO jack is for connection to a video cable with a Type “BNC” connector. Up  
to 300 feet of 75-ohm RG-59 video cable can be used. Longer cable runs may require the  
use of a video amplifier.  
Installation Instructions  
NOTE: If camera is being installed on an existing installation, power must be off  
prior to removing circuit board.  
(760) 438-7000  
REMOVE THESE  
4 SCREWS  
USA & Canada (800) 421-1587 & (800) 392-0123  
Toll Free FAX (800) 468-1340  
2. MOUNT THE CAMERA  
3. CONNECT LIGHTING POWER  
4. REPLACE CIRCUIT BOARD  
RECONNECT THESE  
TWO CONNECTORS  
SECURE THE CAMERA ASSEMBLY  
WITH TWO SCREWS  
REPLACE  
CIRCUIT  
BOARD  
INSERT WIRING  
HARNESS PLUG  
INTO THE 2-PIN  
LIGHTING  
IMPORTANT!  
CONNECTOR  
TO PREVENT INTERNAL  
INFRARED LIGHT FROM  
ENTERING THE CAMERA,  
BE SURE THE FOAM GASKET  
AROUND THE CAMERA'S  
LENS PRESSES FIRMLY AGAINST  
THE RE-1'S FACEPLATE  
SECURE WITH  
4 SCREWS  
5. CONNECT CAMERA CABLE  
6. CONNECT VIDEO CABLE  
LINEAR LIMITED WARRANTY  
This Linear product is warranted against defects in material and workmanship  
for twenty four (24) months. The Warranty Expiration Date is labeled on the  
product.This warranty extends only to wholesale customers who buy direct from  
Linear or through Linear’s normal distribution channels. Linear does not warrant  
this product to consumers. Consumers should inquire from their selling dealer  
as to the nature of the dealer’s warranty, if any. There are no obligations or  
liabilities on the part of Linear LLC for consequential damages arising  
out of or in connection with use or performance of this product or other  
indirect damages with respect to loss of property, revenue, or profit, or  
cost of removal, installation, or reinstallation. All implied warranties, including  
implied warranties for merchantability and implied warranties for fitness, are valid  
only until Warranty Expiration Date as labeled on the product. This Linear LLC  
Warranty is in lieu of all other warranties express or implied.  
PLUG THE CAMERA CABLE  
INTO THE CAMERA'S JACK  
AND THE RE-1'S CAMERA JACK  
CONNECT THE VIDEO CABLE FOR THE MONITOR  
TO THE RE-1'S VIDEO OUTPUT CONNECTOR  
CAMERA  
CABLE FROM  
CAMERA'S JACK  
All products returned for warranty service require a Return Product Authorization  
Number (RPA#). Contact Linear Technical Services at 1-800-421-1587 for an  
RPA# and other important details.  
RE-1  
CAMERA  
JACK  
Copyright © 2007 Linear Corporation  
227793 A  
 

Land Rover Automobile Range Rover User Manual
Learning Resources Baby Toy LRM1762 GUD User Manual
LG Electronics Cell Phone C800G User Manual
LG Electronics Cell Phone VX8550 User Manual
LG Electronics Stereo System LX M150 User Manual
Linear Paint Sprayer 1099 31 User Manual
Magnavox CRT Television MS2730C User Manual
Manitowoc Ice Ice Maker GSI 200 User Manual
Marshall electronic Car Video System V R902DP AFHD User Manual
Melissa Oven 643 192 User Manual